Type mixing structure composed of three parts
1, stirring speed reducer: the reducer series mixer principal transmission mechanism is located on the right side, bring the drive cochlear fight, worm gear work through the chain from the base of the motor driven a 1:51 speed ratio stirring shaft, stirring shaft end sealing means, and must can be disassembled back cap cleaning.
2, mixing tank: slot made ??of stainless steel, built-in stirring paddle, recumbent stirring deceleration pouring reducer.
Pouring reducer: pouring reducer to control the orientation angle of the mixing tank, located on the left side of the machine, working from the base of the motor through a chain belt drive worm, worm wheel driven mixing tank to rotate in a certain expense range make the material once poured.
Groove Mixer check
Before using one empty running test, commissioning observed in various parts device is functioning properly, whether there are special noise reducer temperature is increased, as normal, to get ready for production.
2, the dissolution of mixing pulp: removable stirring, remove both ends of the first and tighten the nut, then pulled out a smooth stirring slurry. The stirring paddle assembly and disassembly should pay attention to the smooth, shall not be a hard knock chaos pry avoid clinching deformation.
Operation if necessary shovel scraping groove wall material, you should use the tool, do not hand, so as to avoid accidents at work.
In use, such as machine vibration abnormal or unusual strange noise should immediately stop checking.
5, the use of the load is not too large, in order to stir the motor operating current of 6.8 amperes normal.
Groove Mixer parts lubrication
Reducer lubrication oil-immersed, 30 # oil before driving to be injected in the left and right gearbox oil for half of the oil standard pour material supporting the oil cup lubrication, once per shift. Once every six months to get a new oil to keep the oil clean.
Groove Mixer 380V AC power supply, stirring time as a result of manual control and self-control, self-control when users rotate button should be placed in a self-control position, and mixing time required for a good tune placed on the hand, the hand control will rotate button can control position. Damage to transmission components, should always check to ensure reliable operation. |
The type mixing part and use the operating precautions